XNUMX Tips XNUMX for FL Studio Beginners to Know
This is the third bullet.
Click here for the first and second bullets
(Unexpectedly, I'm collecting tricks that are super convenient)
This time, there are the following five.
・ Automation is created after selecting a range
・ Swap patterns
・ Know the location of the loaded sample
・ Replace the mixer
Freeze (render)
It is not known unexpectedly, so I will write it repeatedly.
There are cases where it is better to use Wav once when the CPU load is high.
After selecting the pattern you want to freezeCtrl + Alt + c Press at the same time.
The following rendering screen will appear.
Just click "Start".
You can now freeze.
Details are also written in the following article.
Automation is created after selecting a range
If you make an automation clip in FL Studio without doing anything, you will end up with a long automation clip.
To avoid this, simply select a range and then create it, and automation clips will be created for that range.
To select a range, hold down Ctrl and drag the timeline.
And if you create an automation clip, you can create an automation clip only for the selected area as shown in the above figure.
I also prepared a video.
Swap patterns
In the case of FL Studio, it is pattern-based, so if you make it as you think of it, the order will be quite out of order.
However, it will be easier later if you organize the drums from pattern 1 to pattern 10.
Therefore, you can replace the patterns, but you can actually do it by dragging and dropping.
I prepared a video.
Know the location of the loaded sample
You can use it when you want to find a similar sample by opening another folder after loading the sample.
To find out the location of the loaded sample, click the icon with a "t" in the folder icon.
Click to see the location of the sample in your browser.
Swap the mixer
There are quite a few times when you want to change the position of the mixer.
It is an easy way to replace it in such a case.
You can simply hold down the Alt key and move the cursor to the left or right.
The relationship with the mixer assigned to each sound source does not change.
XNUMX Tips XNUMX Summary That FL Studio Beginners Should Know
The accumulation of small things can make a big difference, so I want to keep it in mind.
When you watch a professional track creation video on YouTube, there is really no waste in operation.
This kind of article is a commandment because I forget about it myself.
Comment