[Free] Explanation of Reaktor Block Sequential Switch of Toybox XNUMX
I'm yosi, the caretaker.
Last time I gave an overview of the two things that were added to Toybox's User Blocks.
This time, I will explain Sequential Switch in detail.
Since it has a lot of functions, I will explain it in two or three times.
Parameter explanation of Sequential Switch
Explanation of parameters.
① GATE:If a positive zero cross occurs at the input of Gate etc., the sequencer will
Take one step forward.
In short, when a Gate signal etc. is received, the sequencer advances by one.Zero Cross was explained on Wikipedia.I see.
② RESET:If this input causes a positive zero cross, the sequence will restart.
In the same way as an LFO, the point is that when a reset signal is received by RESET, the sequence is returned to the beginning.
This is the place to set when synchronizing with DAW etc.
If you put "PLAY" in "RESET", it will be played from the beginning every time you press play.
③POS:External step position input value 0 to 1 is step 1 to maximum step
If you input 0 to 1, the sequence advances to the switch at the position corresponding to the value.
④ SNAPT: Select a snapshot by external input.
This is also the same as "POS", and you can select a snapshot here.
⑤ MANUAL GATE: Manually advance the sequence.Right click to reset sequence
You can advance the sequence each time you click.Right-click and then click to return the sequence to the beginning (reset).
⑥ FADE MODE / ROTATE MODE:The sequential switch operates in two modes. FADE MODE and ROTATE MODE.
This is a little complicated, so I will explain it in detail.
FADE MODE
If only the first Input (hereafter Input1) or the first Output (hereafter Output1) is used, all Inputs and Outputs will be aggregated into one.
And when Output2 or later is used, it is output from each Output.
For example, if two or more are connected to Input and only Output1 is used, all the outputs will be output from Output1 when switching in the sequence.
If you connect even one output after Output2 here, it will be a parallel output (Input1 is Output1 and Input2 is Output2).
ROTATE MODE
In ROTATE MODE, each In and Out are connected by rotation as follows.
Step2=2–»1, 3–»2, 4–»3, 5–»4, 6–»5, 7–»6, 8–»7, 1–»8
Step3=3–»1, 4–»2, 5–»3, 6–»4, 7–»5, 8–»6, 1–»7, 2–»8
It's like incrementing each step.
[Free] Explanation of Toybox's Reaktor Block Sequential Switch XNUMX Summary
It looks like a small module and has quite a lot of features, which is amazing.
And it's also surprising that this is free.
I would like to support these developers, so I will continue to write articles in the future.
Comment