How to use Sugar Bytes monosynth CYCLOP (Basic ⑧)
This time it is a manual translation of routing + α.
Next time, I will write a filter, and then I will write a practical edition and finish it.
Routing unit
Cyclop has special routing capabilities for mixing synthesizer and filter signals in different ways. There are four routings available, most of which include a combination of filters and synthesizers.If the filters are operating in series, a distortion unit is placed between them to add sonic spice before the next filter stage.Floating plasma always indicates the direction of travel of the audio signal until it reaches the output indicated by the speaker symbol.
XNUMX types of routing
For the parts that are a little difficult to understand if it is only translation, I added explanations and videos.
1. Parallel
Synth 1 and Synth 2 are mixed.The resulting audio signal will pass through filters 1 and 2 at the same time.The resulting two signals are then mixed to form the final signal.
Synth XNUMX and Synth XNUMX are mixed and enter Filter XNUMX and Filter XNUMX in parallel.
Knob ① determines the degree of mixing of synth XNUMX and synth XNUMX, and knob ② determines the ratio to fielder XNUMX and filter XNUMX.
2. Serial 1
Synth 1 and Synth 2 are mixed.The resulting signal goes through filter 1, through the distortion unit, and then through filter 2.
The synth part is the same as "Parallel", but after filter XNUMX, it goes to filter XNUMX through the distortion unit.
The distortion unit is different from the following.
(The following distortion units can also be used, so you can double-hang them.)
Knob ① is the same as "Parallel", and you can adjust the mix level of synth XNUMX and synth XNUMX, and the input to the distortion unit with knob ②.
3. Serial 2
Synth 1 and Synth 2 are mixed.The resulting signal goes to filter 2, passes through the distortion unit, and then passes through filter 1.
It's almost the same as "Serial 1", just go through filter XNUMX and then go to filter XNUMX.
I don't think it's very useful, but you can easily change the order of filter XNUMX and filter XNUMX, so is it useful for making sounds?I think.
4. Split
The signal from synthesizer 1 is sent directly to filter 1.The signal from synthesizer 2 is sent directly to filter 2.As a result, the two signals are mixed into the final signal.
This is just an explanation.
There is no knob ①, and knob ② determines the ratio of fielder XNUMX and filter XNUMX.
How to use Sugar Bytes monosynth CYCLOP (Basic ⑧) Summary
I didn't know that the "distortion unit" is in a separate routing section. (I was wondering if the location of the master's distortion would change)
I've written it many times, but I can't tell unless I read the manual.
There are some developers who get stuck in the depths when reading the manual, but ...
Comment