How to use Reaktor Create a Multi Slider GUI sequencer

table of contents

I'm yosi, the maintainer of Chillout with Beats.

I've had a lot of time, but I've got a little time so I'll write more.

The BPM synchronization part is a reusable LFO, so if you are the first to read this article, please read from the past articles.

What you might think of a GUI sequencer is the one you often see as below.

It's a hassle with knobs.

Replace Multi Slider GUI sequencer with knobs

Load the previously created sequencer ensemble.

We will replace the knob with a Multi Slider.

Right-click and add "Built-In Module"-> "Panel"-> "Mouse Area".

Double-click the added "Mouse Area", change "Max" of "RANGE X" of "Function" to "16", and set "Step Size" to "1". (To replace the 16-step sequencer)

Then right-click and add "Built-In Module"-> "Panel"-> "Multi Display".

Double-click the added "Multi Display", check "Always Active" in "STATUS" of "Function", and set "X Range" of "RANGE" to "16".

Set "Number" of "OBJECTS" to "16".

Then right-click and add "Built-In Module"-> "Auxiliary"-> "Snap Vaule Array".

Double-click the added "Snap Vaule Array" and set "Array Size" of "RANGE" to "16".

Then right-click and add "Built-In Module"-> "Event Processing"-> "Order".

Right-click and add "Built-In Module"-> "Math"-> "Subtract".

The rest is wiring.

Wire as follows.

Finally, select the module that is Poly as shown below, right-click and click "Set Selection to Mono".

Right-click and add "Built-In Module"-> "Event Processing"-> "Router 1-> M".

Double-click the added "Router 1-> M" and set "Min Num of Ports" of "RANGE" to "16".

Connect as follows.

Delete the knobs and connect them in order.

The final result is as follows.

When the panel is displayed, you should see two squares.

If you put these two on top of each other and click the lock icon, it will operate as a Multi Slider GUI.

In the video below, Size is also changed.

It works as expected.

That's why it's in a certain state, but if you make this, you can use it when you make a synth.

It's much easier to use than a knob.

If the number of knobs increases, it will be difficult for IC Send, so use another method.

That's what I do when I make a synth.

I don't have a lot of time lately, so it may be a little ahead, but I will integrate the filters and start making synths.