How to use the free MH Thump in FLStudio to enhance the bass of your Kick

table of contents

How to boost Kick's bass with free MH Thump in FL Studio
1. Enhance Kick's bass with MH Thump
Summary of how to boost Kick's bass with free MH Thump in FL Studio

How to boost Kick's bass with free MH Thump in FL Studio

This time, I will use the free "MH Thump" to enhance the bass of Kick.

"MH Thump" is good if it is a single Kick, but in the case of Loop etc., it could not be used unless it was para-outed and EQ processing etc. was done because it was caught by a snare etc. with a loud input volume.

The following article explains how to download "MH Thump", so please refer to it.

[Free] Introducing MH Thump that can add bass to Kick

[Free] I'm yosi, the introduction manager of MH Thump that can add bass to Kick.It seems that it has been distributed free of charge for a long time, but it was unchecked.If it's a sampling loop, the Kick is often empty.If you use it in such a case, the core will be solid...

The other day FL Studio upgraded to 20.8Frequency splitterHas been newly added.

Please refer to the following article for the update contents of FLStudio20.8.
(I wrote it in detail)

Updated to FL Studio 20.8 of ImageLine (Explanation of update contents)

Update to ImageLine's FL Studio 20.8 (explanation of update contents) FLStudio update is here! ! !Updates are of course free.Other DAWs cost at least 5 yen, so it's really great.A big update...

Frequency splitterThanks to FL Studio, you can easily perform multi-band processing.

Therefore, the problem that the input detection cannot be adjusted by frequency, which was a weak point of "MH Thump", has been solved.

Enhance Kick's bass with MH Thump

I hang it quite strongly so that it is a little easier to understand.

It's hard to tell the difference unless you have headphones or speakers that produce bass.

To do this, first load "Patcher" into the mixer.

Then open "Patcher" and load "MH Thump" and "Frequency Splitter".

Right-click on "Frequency Splitter" and check "Output"-> "Audio"-> "2. Send 1".

Change "SLOPE" to "96dB", "BANDS" to "2", and "SENDS" to "LOW" to "1".

Then wire as follows.

I also prepared a video.

After that, set "FREQ" to the position where only Kick can hear with "Frequency Splitter".

You can mute the cable by right-clicking on the cable in "Patcher". (Right click again to cancel)

After that, let's open "MH Thump" and add bass.

There are two OSCs, but if the frequencies are close to each other, phase disturbance is likely to occur, so I think it is better to use only one or sweep the other.

Summary of how to boost Kick's bass with free MH Thump in FL Studio

Unless it is already 2Mix etc., I think that it is better to replace Kick than to add bass.

nowMDrum ReplacerSize: XNUMX mL
(Because with Melda's pattern, you can buy at this price at the basic intro sale level, usually 50% OFF is sometimes around $ 80)

I'm also writing an article, so please come.

How to replace the drum loop Kick in FL Studio XNUMX (paid edition)

How to replace the Kick of a drum loop with FLStudio 1 (paid version) Click here for the free version that can be done with FLStudio ・Replace Kick using Slicex 2 ・Replace Kick using Slicex XNUMX Even the free version is practical enough I think, but still...