[Free] Introducing MH Thump that can add bass to Kick

[Free] Introducing MH Thump that can add bass to Kick

I'm yosi, the caretaker.

It seems that it was distributed free of charge for a long time, but it was unchecked.

If it's a sampling loop, Kick is pretty crazy.

If you use it in such a case, the core will be firm and better.

I put it on the Kick of Sukasuka.

In this article, I will send you the following contents.

How to download MH Thump

You can download it by registering your e-mail address.

Go to the link above, enter your email address and click "Send Me Thump!".

You will receive an email with the following subject.

It's hard to understand for a moment, but you can download it by clicking the image on the right.

After downloading, start the installer suitable for the OS and install it.

How to use MH Thump

Thump is a unique audio processor that can synthesize low frequency audio to add a low end to a track or produce a completely different sound. Thump focuses on the pitch and dynamics of the audio input and uses that information to control the oscillator.You can also add low ends to your drums, augment your bass, and create synthetic drones.

Thump is great for enhancing kick drums, adding low ends to percussive tracks, and recreating the sound of classic drum synths.

Thump has two oscillators (OSC).

For these two, OSC detects and triggers the input.

You can use it just by inserting it as an effect.

However, since the input detection cannot be adjusted, the bass may be unnecessarily sounded.

In that case, if you route to another mixer and cut the midrange and above with EQ etc. and adjust it, it will be as follows.

Explanation of parameters

Explanation of the main parameters.

Atk.This control sets the oscillator frequency when the pitch amplitude follower output is at its maximum (for example, when the input signal is full scale).The range for this control is 1 to 440Hz.

Sustain.Frequency: 1-440Hz frequency. Pitch Amplitude Follower Sets the oscillator frequency when the output is at its minimum (for example, when the input signal is silent).The range for this control is 1 to 440Hz.

In short, specify the frequency output by the oscillator when the input signal is maximum and minimum.

Sweep from 440Hz to 1Hz with Atk at maximum and Sust at minimum.

The important thing is that Atk reacts differently depending on the level of input.

When the input is maximum, the frequency set in "Atk. Frequency" sounds, but when the input is low, the frequency also drops.

I took a video.

– The Envelope Atk., Pitch Atk .: Sets the attack time constant for each amplifier follower in milliseconds.The attack time constant controls how quickly the envelope output increases when the level of the input signal is higher than the envelope output.The smaller the value, the more the envelope will follow the signal, but if it is too small, it can cause distortion depending on the characteristics of the input signal.

– The Envelope Sust., Pitch Sust .: Sets the release time constant for each amplifier follower in milliseconds.The release time constant controls how quickly the envelope output decreases when the level of the input signal is lower than the envelope output.The smaller the value, the more the envelope will follow the signal, but if it is too small, it may be distorted depending on the characteristics of the input signal.

Attack and release settings.

When changing these settings, it is easier to understand if Mix is ​​set to Wet 100%.

[Free] Summary of introduction of MH Thump that can add bass to Kick

It's free but pretty good.

It ’s also equipped with two OSCs.Little footIt's a feature that you don't have, so you have more choices.

Free plug-ins need to be selected.