How to use FL Studio How to make a multi-band stereo imager using Patcher
I've run out of time after replacing the C drive, so this is a light article.
I tried to make a XNUMX-band version of Spread, which is paid by Yam Audio, with Patcher.
If you have Ozone Standard or above, Ozone 9 Imager supports multi-band, so you don't need to make it with Patcher.
Create a multi-band stereo imager with Patcher
It is like this.
The bass is in the center and the others are wide.
Please choose your favorite stereo imager.
Free hereSpread LightIs used,Ozone Imager 2Is also good.
Spread LightPlease refer to the following article for details.
Ozone Imager 2 feels more stereo, but the advantage of Spread Light is that you can swing the Pan.
Let's make it.
First, use "Frequency Splitter" in "Patcher" to create a multi-band.
Load "Patcher" into the mixer, open it, and load "Frequency Splitter".
Then right-click on "Frequency Splitter" and click "Outputs"-> "Audio"-> "2. Send 1" to enable it.
Enable "3.Send 2" and "4.Send 3" in the same way.
After that, the version is upgraded and the context menu type displayed by right-clicking can be operated continuously without closing by right-clicking as it is.
It's hard to convey in words, so please watch the video.
This completes the output for XNUMX bands.
Double-click "Frequency Splitter" to open it.
Drag the red frame in the figure below to make it "1", "2", and "3", respectively.
Now each band and Output has been assigned.
All you have to do is delete the cable that is currently connected and connect the remaining three to "To FL Studio".
hereSpread LightWill be read.
You can easily connect by dragging from the browser and dropping on the cable.
I prepared a video.
How to use FL Studio Summary of how to make a multi-band stereo imager using Patcher
The drumOzone Imager 2You can feel better if you do it with.
You can spread the Kick to the left and right. (Bass is in the middle)
Comment