Create a Lo-Fi Delay using FL Studio's Patcher

I didn't have time, so WavesHow to use COSMOSIs a holiday.
(I will write more tomorrow)

Cymatics'sLOTUSI was trying various things to see if I could reproduce it with Patcher, but I derailed and made a Lo-Fi Delay.

I got it for free beforedirty tapeIt was pretty good to just hang it on Delay.

It is like this.

最初dirty tapeIs on and then switched to Off.

Finally, I also tried reverse with Gross Beat.

Reverse with Lo-Fi is good!

Then how to make it immediately.

How to create a Lo-Fi Delay using the FL Studio Patcher

First, load Patcher into the mixer.

Then load the Delay and Dirty Tape.

Delay is Valhalla's again this timeValhalla Supermassive.

[Free] Introducing Valhalla Super Massive, which does not seem to be free

[Free] Introduction of Valhalla Super Massive, which is hard to believe it's free.If you haven't used it yet, please try this plug-in before purchasing paid Delay or Reverb.Another free preset...

chilloutwithbeats.com

2023.02.02

This time I tried not to let the Dry sound pass through the Dirty Tape.

This is because if you apply Dirty Tape strongly, it will become Lo-Fi too much and will be buried.

Wiring should be as follows.

Dirty Tape settings

I will also write down the settings I used.

It's a little hard to see, but "DRIVE" is about "8".

"DIRTY" is maximized.

"STEREO MODE" is set to "DE-COUP LED".

If you think that the bass is an obstacle depending on the material, please insert "LOW CUT".

If you set "STEREO MODE" to "DE-COUP LED", it will randomly spread to the left and right, which is interesting.

In the video below, the first is "DE-COUP LED" and the last is "NORMAL".

You can see that the Delay sound sometimes moves from side to side.

Valhalla Supermassive settings

Valhalla Supermassive just set the preset Kingswood and then set "MIX" to "100%".

If you copy and paste the following contents, the preset parameters will be the same.

Valhalla's plugins make it easy to copy and paste presets.

I took a video of how to do it.

Add reverse

Let's add more reverse to Delay.

Load Gross Beat and wire as follows.

Gross Beat settings

Gross Beat has the following settings.

The following settings are also interesting.

It is like this.

Summary

Dirty Tape is simple but quite usable.

Patcher makes it easy to process Dey and Wet separately.

This time I did it with Dirty Tape, but it is also interesting to use other Lo-Fi plug-ins.

It's also interesting to put the chorus after Delay.

Please try various things.