[Free] How to make a toremono with Patcher, learning from Goodhertz's effects

Goodhertz'sTrem ControlI thought it was so good that I couldn't reproduce it.

In particular, I thought that the parameter "Harmonic" called "Term Type" was good, so I tried to reproduce this with Patcher.

The feature of "Harmonic" is that the Tremono effect is applied only to the high notes.

The original looks like this.

It looks like this when reproduced with Patcher.

It's pretty simple, but it feels pretty good.

The point is to make Tremono hang only on the high notes.

table of contents

How to make Tremono with Patcher

First, insert the "Patcher" into the mixer.

Next, load "Fruity peak controller", "Frequency Splitter", and "Fruity Balance" into "Patcher".

Only high can be output.

First, open "Frequency Splitter" and set "BAND" to "2".

Next, turn "LOW" off.

Right-click on "Fruity Balance" and click "Input"-> "Parameters"-> "2. Volume".

You can enter the parameters as follows.

Right-click on "Fruity peak controller" and click "Outputs"-> "Controllers"-> "3. LFO".

Connect as follows.

After that, open "Fruity peak controller", raise "VOL" and adjust "SPEED".

I also prepared a video.

After that, you can change the LFO or change the "TENSION".

It's pretty simple, but isn't it pretty good?

You can also add saturation or chorus if you like.

Patcher should have a high degree of freedom.

I could do the same thing with Multipass and it was easy.
(The LFO waveform has more variations in the "Fruity peak controller")