Concept
This is yosi from Chillout with Beats.
For the time being, Native Instruments' MaschineTruTrials I will go deeper and accumulate ideas.TruTrials The video is only a few minutes short, so it's good to use it as a reference, but for Maschine beginners, it's only in English, so I think it's a little difficult. (I also looked back many times, and I wondered if I would do this many times ...) After thatTruTrialsI will try using this method in my own way, make trial and error, and record the results on my blog.
REVERSE THE REVERB
Watch the video as usual.
In short, let's cut out only the reverb on the snare and flip it over!about it.
It's an effective sound when used before entering the rust or at the end of the break.
The procedure is as follows
- REVERSE THE REVERB
- Record Snare
- Add Reverb
- Re-Sample to Next Pad
- Edit Sample
There are few steps, but if you watch the video, it requires a little editing.
Internally route and record the snare
Remove the attack part of the snare and reverse the reverberation part
Result
The sound of a snare with reverb (I think it's better not to have a snare ...)
This is the snare followed by the riff and drum
Somehow the snare is no longer relevant, but ...
It became fun from the middle and it turned off.
Comment