How to use Avenger How to output ARP or SEQ by MIDI in FL Studio XNUMX

DTM
Sponsoring

How to use Avenger How to output ARP or SEQ via MIDI XNUMX

I'm yosi, the administrator of Chillout with Beats.

I was doing a lot of research, and I thought it would be nice if I could output Avenger's ARP or SEQ and play it on another synth. (There are just a few tips)

Avenger is heavy, so it's better to substitute the parts that can be replaced by other synths.

 

AvengerBecause it is heavy, it is also possible to disable the synth part and use it as a pattern generator.

And as I wrote in yesterday's article, if you use the Burn to MIDI function of FL Studio to export MIDI, you only need to start one Avenger.

It ’s actually lightSektor Synth,Sylenth1If you use around, you can make it even on a fairly old PC.

More and more for DTM beginnersAvengerThere are more reasons to recommend.

Then I will explain how to do it immediately.

MIDI output from Avenger

It will MIDI out the arpeggiator and sequence just like a normal MIDI plug-in without doing anything. (splendid!)

Due to the characteristics of Avenger, MIDI of multiple instruments will be output, so it is necessary to turn off some of them.

Advance preparation

Start Avenger.

Click the gear icon in the upper left and set the "Output port" of "MIDI" to "0".
(Here, "0" is set, but anything is OK as long as it is aligned with the receiving side.)

Then start the synth that receives MIDI.

Here we launch a cheap and light Sector.
(As an aside, if you buy it on sale, the aim is 3 yen or less)

Click the gear icon in the upper left and set the "Input port" of "MIDI" to "0".

This completes the preparations.

MIDI output is already done in this state, so please play something on the Avenger side.

 

1. How to select an Arp preset and output it via MIDI

First of all, it is a method of MIDI output with your favorite Arp.

Here, I loaded the preset "AR Make Me Horny".
Any preset that is not a layer is OK.

Load the appropriate Bass preset on the Sector side.

I used "Derty Wubz" here.

If this is left as it is, sound will be output from both Avenger and Sector, so turn down the volume of Avenger.

After that, change the preset appropriately and try to find your favorite phrase.

2. How to select an Arp phrase preset and output it via MIDI

If you use the method of "1.", the synth and effects will be loaded together, which will increase the CPU load.

To reduce the load and utilize the MIDI output, initialize the preset once and then select the Arp phrase.

First, initialize the preset you are currently loading.

A warning will be displayed. Click "Yes".

Then enable "Arp" and disable everything else.

Click the red frame in the figure below "Arp" to display the phrase presets. Here, select "Industry".

It's a little difficult to understand, so I prepared a video.

With this, you can utilize the phrase with the minimum CPU load.

How to use Avenger How to output ARP or SEQ via MIDI XNUMX

You can use it as a phrase generator as well as how to use Avenger.

However, changing the phrase pattern is troublesome if it is left as it is.

From the next time onward, we will send you the following contents.

・ MIDI output to change phrases
・ MIDI output of SEQ
-MIDI output of drum phrases

 

Sponsoring
Sponsoring
[themoneytizer id = "118573-6"]
DTM
Chillout with Beat

Comment