[Free] Introducing Auroradsp's impulse loader FenrIR
I'm yosi, the caretaker.
FenrIR is a free impulse loader suitable for guitar cabinets.
Free is good with this feature!
The feature is that two impulses (hereinafter referred to as IR) can be read and the start position can be adjusted.
Since the IR of the guitar is very short, a phase problem will occur when using multiple guitars.
Since the phase can be adjusted extremely easily, sound creation will proceed efficiently.
Let's take a look at it.
How to download FenrIR
The link below will take you to the official page.
Click Add to Cart.
There is also a free IR, so let's add it to the cart as well.
Click "Home" at the top of the screen to go to the top page of the site.
If you scroll a little, you will find "PALMER 212 G12-T75 IRs PACK", so also "Add to Cart". (There are only 2 IR files, but let's get it)
Click Proceed to Checkout.
Click Proceed to Checkout again.
Enter your name and email address. (Select Mr. (male) or Mrs. (female))
To create an account, enter your account name and password.
(Not required)
Check "I agree to the terms and…" and click "Continue".
Enter the address on the next screen.
It's okay if it's relatively appropriate.
It is better to enter a dummy address on the free site.
If information leaks, they don't guarantee anything.
(Since it is basically Paypal payment, you should not need to enter the address etc.)
Click Continue when you are done.
Check "I agree to the ..." and click "Order with an obligation to pay"
Suddenly, the following screen will be displayed and you may think "that?", But the URL to download by e-mail has arrived, so let's check it.
The subject is as follows.
[Aurora DSP – VST plugins, bass, guitar] The virtual product that you bought is available for download
After downloading, install it.
How to use FenrIR
How to load IR
Fenr IR can read two IRs.
After loading, you can load IRs in the same folder one after another by clicking "<>".
It can also be read by dragging and dropping.
The role of the two IR Players
These two IR Players operate as a guide IR and a follower IR.
You can decide whether to use the upper or lower IR Player as the guide IR in the "Guide" at the top of the screen.
Guide IR detects transients.
A guide is displayed in the follower IR when the transient was detected.
Move this vertical line with the bar below to make the guide bright green.
When the follower IR and guide match, the indicator turns bright green.
It's hard to understand, so I prepared a video.
Can you see that the sound becomes solid when the guide turns bright green?
Other functions
① Switch View
The display of IR waveform and frequency distribution can be switched.
(XNUMX) Phase inversion switch
The phase can be inverted.
③ Blend of IR Player 1 and IR Player 2
You can adjust the blending condition of IR Player 1 and IR Player 2.
It is a blend of exactly half and half in the middle, and can be adjusted on the left (Player1) and right (Player2), respectively.
④ Master volume
You can adjust the master volume.
⑤ Export the blended IR
It is possible to export in a blended state.
[Free] Summary of introduction of Auroradsp's impulse loader FenrIR
It's amazing that you can do this for free.
Free IR is covered in this blog, so please check it out.
Comment